1. Prohibit unprofessional disassembly

The internal structure of fingerprint locks is much more complex than traditional mechanical locks, in the process of installation and setup, do not casually disassemble; any problems directly consult the after-sales personnel of the fingerprint locks, which Wrigley Intelligent Technology's after-sales service is still very reliable. This also tells us that when buying smart locks, it is important to choose a manufacturer with good quality after-sales service.

2. Battery selection

Battery selection should be careful; try to choose large-capacity AA alkaline batteries. If the battery power is insufficient, replace the batteries promptly to ensure the normal use of the door lock. If you fail to replace the batteries in time, you can use an external power supply for emergency unlocking. Choose batteries with brand quality assurance and occasionally check the battery compartment to prevent leakage. Fingerprint locks should be protected from water. Fingerprint locks differ from ordinary mechanical locks as they contain electronic components or circuit boards, which are not waterproof. Therefore, minimize direct contact between the fingerprint lock and water.

3. Pay attention to moisture

After a long period of use, wipe the dirt on the surface of the capture window with a soft cloth, and use a dry soft cloth to instantly clean the moisture on the surface to avoid affecting the sensitivity of fingerprint capture.

4. Avoid chemical corrosion

Avoid using corrosive chemicals to clean the fingerprint lock. Most fingerprint lock casings are made of zinc alloy and stainless steel, so you should not use corrosive chemicals to scrub or contact the fingerprint lock. This is to prevent damage to the protective layer of the lock surface and to avoid affecting the gloss of the lock's surface. For oil lubricants, general locks may experience difficulty with smooth key insertion and extraction after long-term use. In such cases, you can add a small amount of graphite powder or pencil powder into the lock body slot to ensure smooth key insertion and extraction. However, do not add any oil for lubrication, as this could cause grease to stick to the spring, resulting in the lock being unable to turn or open.

5. Mechanical key dragged on the proper placement

Emergency mechanical key properly placed, the general case of fingerprint locks emergency mechanical key placed outside the room of the lock control, to be used to unlock the time, can be taken out in time to use.